BOLL Fibreglass Polyester Resin Repair Kit

A polyester resin repair kit for filling larger holes and damaged areas in vehicle bodies, boats and trailers.

Also suitable for reinforcing and stiffening repaired components.

The resin provides very good adhesion to metal, plastics, glass, wood and concrete.

It combines flexibility with a short curing time and high mechanical strength once cured.

The finished repair can be sanded and covered with polyester fillers.

Resistant to temperatures up to 80°C, weather conditions, petrol, lubricants, oils, diluted acids and alkalis.

KIT CONTENTS

• Polyester resin: 242 g
• Hardener: 8 g
• fibreglass mat: 0.25 m²

COLOUR

• Yellowish

INFORMATION

Do not apply directly over reactive primers (wash primers), one-component acrylic products or nitrocellulose products.

Do not return unused resin mixed with hardener to the original container.

SURFACE PREPARATION

Steel and aluminum

Sand the surface, blow off the dust and degrease with BOLL Silicone Remover before applying the resin.

Existing paint coatings, two-component acrylic primers and epoxy primers

Sand with P150-P240, blow off the dust and degrease with BOLL Silicone Remover before applying the resin.

Polyester laminates

Sand with P80-P120, blow off the dust and degrease with BOLL Silicone Remover before applying the resin.

Plastics

Sand with P120, blow off the dust and degrease with BOLL Silicone Remover before applying the resin.

APPLICATION

1. Thoroughly clean and sand the surface to achieve a matt finish.

2. Remove the dust and degrease with BOLL Silicone Remover.

3. Cut the fibreglass mat so that it extends approximately 2 cm beyond the edges of the damaged area.

4. Mix the resin and hardener in the following ratio by volume:

• Resin: 100 parts
• Hardener: 2-3 parts

Alternatively, mix by weight:

• Resin: 100 g
• Hardener: 3.3 g

5. Mix thoroughly until a uniform colour is achieved. Do not exceed the recommended amount of hardener.

6. Pot life of the prepared mixture: 10-12 minutes at 20°C.

7. Use a brush to apply the mixed resin to the prepared area.

8. Position the pre-cut fibreglass mat and press it down.

9. Thoroughly saturate the mat with resin. Depending on the size of the repair, apply additional layers of mat, repeating the application and saturation steps.

10. Allow to cure for approximately 45 minutes at 20°C.

11. Sand the laminate with P80-P120 abrasive paper or level the surface with polyester filler.

PHYSICAL PROPERTIES

Density at 20°C: 1.06-1.16 g/cm³
Application temperature: +10°C to +25°C
Temperature resistance: Up to 80°C

CLEANING

Clean tools immediately after use with a thinner intended for nitrocellulose or acrylic products.

STORAGE

Protect the product from excessively low and high temperatures.

Avoid direct exposure to sunlight and store in a dry place.