BOLL
BOLL Underbody Coating - Brushable
Specially formulated agent, that forms a strong, flexible layer resistant to mechanical damage and effects of chemicals found on the road. It has excellent sound absorbing properties.
Available options
3 variantsBuy by the carton (trade)
12 units / carton£75.49 inc. VAT (£62.91 ex. VAT) per carton of 12 · 10% trade discount.
Technical specifications
- Application temp.
- 15°C to 30°C
- Packaging
- can
Safety & documentation
Hazards
Flammable
Harmful or irritant
Serious health hazardThis sheet covers the option selected above. Always verify product specifications and safety information before use.
More about this product
The bitumen and rubber-based underbody protection agent forms a flexible coating that perfectly protects the car's underbody from stone, salt, water and mechanical impacts.
It is resistant to sprinkling salt and industrial exhaust fumes.
It also has a sound-absorbing effect.
Surface Preparation
Epoxy primer :
Can be used to isolate materials. Sand with P320, blow off sanding dust and de-grease using BOLL Silicone Remover, then apply another coat.
Two-component acrylic primer :
Apply a guide coat or control powder. Sand with P240–P320, blow off sanding dust and de-grease using BOLL Silicone Remover, then apply another coat.
Polyester putty :
Sand with P120–P320, blow off sanding dust and de-grease using BOLL Silicone Remover, then apply another coat.
Important Information
Do not apply to the engine, gearbox, brake components or exhaust system.
Do not paint over the coating.
Application
1. Thoroughly clean and matt the surface.
2. Thoroughly clean and de-grease the surface using BOLL Silicone Remover.
3. For corroded surfaces, we recommend using BOLL Rust Converter or BOLL Anti-corrosive Paint.
4. Mix the product thoroughly.
5. Apply evenly using a brush.
6. Apply a coating thickness of 2–4 mm.
7. Allow approximately 5–7 hours for the coating to dry at 20°C.
8. After 24 hours, the vehicle is ready for use.
Physical Properties
- Density at 20°C: 1.30 g/cm³
- Application temperature: +15°C to +30°C
Cleaning
Wash the brush using nitrocellulose thinner (Nitro) or white spirit.
