BOLL Anti-Corrosive Red Oxide Primer Paint - CAN

This anti-corrosion primer paint, based on alkyd resin, provides excellent adhesion to a variety of substrates and effective protection against external factors.

It is ideal for priming steel and cast iron and can be used as a base for phthalate, chlorinated rubber, acrylic, and polyurethane paints, as well as and bitumen used in car body repairs.

Colour

• Oxide red

Method of Use

Mix the paint thoroughly before use. It can be applied using a brush, roller or pneumatic spray gun.

When applying with a spray gun, thin the paint to the required viscosity using BOLL Acrylic Thinner or xylene.

Apply 1–2 layers, allowing a minimum of 1 hour between coats.

• Application temperature: Above 10°C
• Maximum relative humidity: Below 80%

Application Parameters

Brush or roller

• Viscosity: Ready for use
• Recommended number of layers: 1

Pneumatic spray gun

• Viscosity: 25–35 seconds
• Nozzle size: 1.5–2.0 mm
• Air pressure: 0.3–0.5 MPa
• Recommended number of layers: 1–2

Dipping

• Viscosity: 25–35 seconds
• Recommended number of layers: 1–2

Application

1. Sand the surface and remove any loose rust fragments.

2. Thoroughly clean and degrease the surface using BOLL Silicon Remover.

3. Mix the paint thoroughly.

4. Application by brush or roller

Apply 1 layer.

5. Application using a pneumatic spray gun

Apply 1–2 layers using a 1.5–2.0 mm nozzle.

6. Allow a minimum evaporation time of 1 hour between coats.

7. Allow approximately 24 hours for complete drying at 20°C.

Physical Properties

• Viscosity: 75 seconds, Ford Cup 4 mm at 20°C
• Density at 20°C: 1.3 g/cm³
• Solids content: 60%
• Layer thickness: 35 µm
• Thinner: Thinner for acrylic products or xylene

Drying Times

• Dust-dry: 25 minutes
• Ready for the next coat: 60 minutes
• Complete drying: 24 hours

Application Conditions

• Application temperature: +5°C to +25°C
• Relative humidity: 40–65%